Product Description This Set of 10 Krups BeerTender Tubes will keep your beer fresh and delicious. Using a new tube with each new keg is recommended to ensure the perfect flavor every time. Secure a perfect fit between the Krups BeerTender home beer-tap system and a Heineken or Heineken Premium Light DraughtKeg thanks to this 10-count package of BeerTender tubes. Each new DraughtKeg requires a fresh tube and installation's a snap. Step-by-step instructions are available right on the bag, which measures 15-2/5 by 10-2/3 by 1-8/9 inches.
BeerTender TubesOctober 9, 2008 Heinekin BT10001 BeerTender Tubes, for using with the BeerTender, are fine. I have no problem with them at all.
Heineken BeerTender Disposable TapsSeptember 30, 2008 If you love beer as much as I do, then you won't be disappointed in the new Heineken Mini Draft Machine for the home bar. I really think that Heineken hit a home run with this machine. I would prefer that they create a beer tube that was "washable and reusable", but the cost is no issue here and the ease of use makes it a mute point.
Reusable If You're CarefulSeptember 28, 2008 1 out of 1 found this review helpful
The BeerTender recommends using a new tube for each mini-keg, and at about a dollar each that's not a big deal. However, if you have run out of tubes, or just want to be thrify, they can easily be reused at least a couple times. Here's how:
o Put the empty mini-keg in a sink. o With the tube's spout pointing toward the drain, push the two white barrel fittings together. This manually operates the tap to relieve pressure in the mini-keg. o Wait a few seconds for all the foam to drain out. o Use a screwdriver or butter knife to remove the top part of the tap. There are three tabs on this gray cover piece; pry back one or two to lift it off. o Remove the part still attached to the mini-keg by pushing back the tabs holding it to the top of the keg. Use a screwdriver or butter knife on the inside part of the tap - accessible with the cover removed - to release these tabs. o Thoroughly rinse the tap, tube, and spout. With the barrel connectors still pushed together, run a stream of water into the spout and it should drain through the tube and out the small holes in the tap. o Snap the cover piece back onto the tap with the larger hose cut-out aligned with the tube. o Pull the barrel connectors apart to manually close the tap to make it ready it for the next mini-keg. Be sure the whole thing is very clean, especially if not using immediately.
I've used one tap three or four times, and it still works fine (no leaks, similar pour). I suspect they recommend using a new one every time because it can be messy removing it from the mini-key and the potential for it to get moldy if not cleaned.
Don't forget the part about relieving the residual pressure, or you will probably have a beer geyser when the gray cover is removed.
As advertisedSeptember 20, 2008 Not much to say here. They do what they are supposed to. They are hard to find locally.
VERY PLEASEDSeptember 18, 2008 THE PRODUCT WAS A VERY GOOD DEAL IF YOU BOUGHT 3 PACAKAGES, WHICH I DID. THE SHIPPING WAS FREE & THERE ALSO WAS A SLIGHT DISCOUNT. THE PRODUCT WAS ALSO SHIPPED BEFORE THE DATE PROMISED.
